Can anyone either tell me or send me a picture of how the bottom two halfs of the NC24 fairing fit together please.
Iv got two pieces of metal (well like tags) but they wont seam to fir together, iam missing something?
NC24 Fairing Fit?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
christ044
- Settled in member
- Posts: 114
- Joined: Mon May 12, 2008 7:35 pm
- Bike owned: NC24
- Location: Isle of Wight
-
spooky
- Site Supporter
- Posts: 429
- Joined: Wed Apr 30, 2008 8:37 pm
- Bike owned: nc24
- Location: Newtownards Co.Down N.Ireland
Re: NC24 Fairing Fit?
Thats what I'd like to know too. Mine has an R shaped clip on it and a cable tie, Has anyone got the right bits on and what are they like. 
\That wee smilie can drink some Guinness. No wonder he's yellow.
-
christ044
- Settled in member
- Posts: 114
- Joined: Mon May 12, 2008 7:35 pm
- Bike owned: NC24
- Location: Isle of Wight
Re: NC24 Fairing Fit?
Mine just flaps in the wind 
There must be some sort of clip or something that holds them together?
There must be some sort of clip or something that holds them together?
-
Manticorp
- Settled in member
- Posts: 33
- Joined: Thu Oct 30, 2008 11:34 am
- Contact:
Re: NC24 Fairing Fit?
I would go out and check now but the heavens have been open for a couple of hours now and I don't wanna go out in the cold and wet 
I remember coming across this problem though and there's a bit of a knack to getting it to clip together, I seem to remember each side having alternating tabs which need to lock together - a pig of a job for one person, but assembling it under the bike while it's on the floor then bolting it on seemed to do the trick.
I Seem to remember having to tilt both fairings away from eachother and tilting them back into eachother to get the pieces to lock? :/
If this doesn't help I'll go out n have a look, but good luck :)
Having them flapping around eventually caused one half of my fairing to fall off while riding
I remember coming across this problem though and there's a bit of a knack to getting it to clip together, I seem to remember each side having alternating tabs which need to lock together - a pig of a job for one person, but assembling it under the bike while it's on the floor then bolting it on seemed to do the trick.
I Seem to remember having to tilt both fairings away from eachother and tilting them back into eachother to get the pieces to lock? :/
If this doesn't help I'll go out n have a look, but good luck :)
Having them flapping around eventually caused one half of my fairing to fall off while riding