CBR race bike design

[Hybrid29]

I like the look of the standard cbr400 decal design but I want it to have a different colour scheme not red and blue

https://www.dropbox.com/s/2yhschbk8yq5q ... w.jpg?dl=0

I would like it printed out similar to this colour scheme (black grey and white)

https://www.dropbox.com/s/6rer738163nl4 ... c.jpg?dl=0

I only need the front fairing section and tank stickers and not the seat decals as my rear seat fairing is of a rs125 and a lot smaller than the standard one

https://www.dropbox.com/s/3816j6dg7ul2r ... 3.jpg?dl=0

I have just emailed imageworks to see if it can be done has anyone else done anything similar ?

[Foxy400]

I like that alternative RVF colour scheme..good choice. If you don't hear back from Imageworks I'd give them a call. I found they're sometimes a bit slow to respond to emails but they pick up the phone pretty quick and you'll get an instant answer to your question.

Also just discovered Awesome Graphics in a NC29 restoration article in Practical Sportsbike. Looks like they create standard stickers to your specific colour requirements, just what you're looking for

Ha,ha! I've just realised you're in the land of the Kiwi..I guess a phone call might be a bit pricey.

[Hybrid29]

I have made it bit of progress over the last few weeks their is two trackdays in April and winter is coming ,so I am trying to get the bike sorted before its gets too cold wet and crappy

Fairing are currently getting the decals applied I should have them back next week im so hoping they will look as good as I hope

https://www.dropbox.com/s/ynhn3gbpep65v ... 1.jpg?dl=0

https://www.dropbox.com/s/85c5jlw5k70zd ... 9.jpg?dl=0


https://www.dropbox.com/s/l6wt1hrpdlkfe ... 9.jpg?dl=0

[Davez29]

Well those graphics are a lot closer to the original design than I have seen before from other third party decal manufacturers.

Where did you get them from?

One little tip i learnt, on the large Honda decal, tape it fully along the top in position and now cut between each letter and you can then carefully peel and lay each letter down one by one.

[Hybrid29]

https://photos-1.dropbox.com/t/2/AACtfe ... ize_mode=3

https://photos-2.dropbox.com/t/2/AACd4n ... ize_mode=3

[Hybrid29]

Well those graphics are a lot closer to the original design than I have seen before from other third party decal manufacturers.

Where did you get them from?

One little tip i learnt, on the large Honda decal, tape it fully along the top in position and now cut between each letter and you can then carefully peel and lay each letter down one by one.

I got them from imageworks ,
and i ended up paying someone to put them on because I screwed it up first time around