Page 5 of 5
Re: Tyga fairing
Posted: Sun May 07, 2017 1:47 pm
by MarkVanDamme
Hi
The kit does not come with fasteners, so what do you do about joining the fairing when the original panels had 1/4 turn dzus screws?
Sent from my SM-J320FN using Tapatalk
Re: Tyga fairing
Posted: Mon May 08, 2017 8:20 am
by Dynamohum
I have an rvf tyga painted kit which was supplied with fittings spire clips screws etc for joining upper and lower section although not dzus type 1/4 turn .
If your buying from jap4 or tyga direct you could get them from them or if someone knows the size of clips dzus fasteners if thats your preference many other places.
Re: Tyga fairing
Posted: Mon May 08, 2017 11:34 pm
by jedidude04
Tyga supply their kits with m6 clips i think, just put the clip over the hole and its a steel thread that you put the screw in..
Though this depends on the size of the hole, dzuz fasteners may have had the fairings drilled out