Advise me please
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Reactions:
- Posts: 6
- Joined: Wed May 28, 2014 7:40 am
- Location: ACT, Australia
Advise me please
Hey all!
not sure if this is the correct place to post this (m question fits all the categories)
I've begun to personalise my bike a bit and have decised I want to attempt something a little bit different in regards to my fairings.
I've decided upon the tyga front fairing kit (most likely the tyga eyes III version) but I don't fully like the tyga rear fairing.
What I've been thinking of doing is something along the lines to what I have seen done before, and here is where my questions and lack of knowledge come into play (hopefully your collective knowledge will be some help)
How difficult/troublesome is it to fit, say a ducati 848 fairing to either my existing subframe, or fitting an 848 subframe to my frame and going from there?
I work somewhere where experienced welders and engineers also work so if worse comes to worse and I need their help it can be sourced.
tl;dr: How hard is it to fit a different bike's fairing and subframe to a NC35?
thanks in advance and watch the project space for a new thread :D
not sure if this is the correct place to post this (m question fits all the categories)
I've begun to personalise my bike a bit and have decised I want to attempt something a little bit different in regards to my fairings.
I've decided upon the tyga front fairing kit (most likely the tyga eyes III version) but I don't fully like the tyga rear fairing.
What I've been thinking of doing is something along the lines to what I have seen done before, and here is where my questions and lack of knowledge come into play (hopefully your collective knowledge will be some help)
How difficult/troublesome is it to fit, say a ducati 848 fairing to either my existing subframe, or fitting an 848 subframe to my frame and going from there?
I work somewhere where experienced welders and engineers also work so if worse comes to worse and I need their help it can be sourced.
tl;dr: How hard is it to fit a different bike's fairing and subframe to a NC35?
thanks in advance and watch the project space for a new thread :D