Page 21 of 27
Re: CBR400RR exhaust thread
Posted: Mon May 28, 2012 5:28 pm
by PARUS
vr46 wrote:Yep, but what about the system? You can't tell by the poor photo, but the exhaust system is sprung and the rear link pipe is much higher than standard.
BEET titanium based of the color I think.
Re: CBR400RR exhaust thread
Posted: Mon May 28, 2012 5:59 pm
by vr46
Nope, a Beet system hangs lower. I've found photos of the same exhaust on here :
Edit: It looks like a matched can / system; The end can bolts on perfectly - no surplus edges.
Re: CBR400RR exhaust thread
Posted: Mon May 28, 2012 6:08 pm
by Yakama
It could be a moriwaki system as they did do full systems with that end can or it could be a yoshimura system as they had balancer pipes too.
When I get home I will post up pics of each so you can compare them
Re: CBR400RR exhaust thread
Posted: Mon May 28, 2012 9:04 pm
by Yakama
Ok so the yoshimura system:
But I now dont think it is this
Re: CBR400RR exhaust thread
Posted: Mon May 28, 2012 9:06 pm
by Yakama
Re: CBR400RR exhaust thread
Posted: Mon May 28, 2012 9:22 pm
by vr46
Thanks Yakama!
That looks like the one, even the Hanger bracket is the same.
Re: CBR400RR exhaust thread
Posted: Mon May 28, 2012 9:29 pm
by Yakama
You thinking of buying the system or the bike?
Re: CBR400RR exhaust thread
Posted: Wed Jun 27, 2012 7:30 pm
by joeya
Hey guys, got this system nearly two years but finally getting around to rebuilding the bike.
The ebay ad said "...NC29 Moriwaki Titanium race exhaust", it came in 7 pieces (8 including an additional link pipe made from stainless, not pictured)
Any idea what it is? The reason for the odd colour is thats its just been sand blasted, not sure if it is Titanium but its super light weight.
IMG_1246 by
Joe Alner, on Flickr
IMG_1247 by
Joe Alner, on Flickr
IMG_1248 by
Joe Alner, on Flickr
Cheers!
Re: CBR400RR exhaust thread
Posted: Fri Jun 29, 2012 8:42 pm
by willpisme
Hi all just a quick question about the GF racing nc23 exhaust slip on adapter. Does it just fit direct onto the original exhaust flange or do i need to cut off the flange down to the bolt face? If that makes sense!
Sorry if this is a bit obvious but wanted to double check before hacking away!
Re: CBR400RR exhaust thread
Posted: Sun Jul 15, 2012 9:24 am
by hawksuspension
Blimey!!! so thats a hrc one for deffo then?? Have identical one sat here...was never sure on make