batchelor wrote: ↑

Sun Oct 06, 2019 7:59 pm

I’ve just fitted the rubber to the side stand as it was missing. I have a couple of questions

1 which way does it fit into the stand
2 which way does it bend when bike is on side stand (forwards or backwards)

NGneer wrote: ↑

Thu Oct 17, 2019 9:22 am

batchelor wrote: ↑

Sun Oct 06, 2019 7:59 pm

I’ve just fitted the rubber to the side stand as it was missing. I have a couple of questions

1 which way does it fit into the stand
2 which way does it bend when bike is on side stand (forwards or backwards)

Batchelor: There is an arrow on the rubber which wants to be on the outside face (when the stand is down) and the angle of the bottom of the rubber will naturally make the rubber bend BACKWARDS when you put the stand down. It is true this was due there being no side stand cut out Switch on the NC30 and the rubber foot was there (in theory) to flick the side stand up if you left it down, before it dug into the deck and spat you off.

batchelor wrote: ↑

Thu Oct 17, 2019 12:43 pm

Cheers for the information and pics. That’s a very clean bike.

NGneer wrote: ↑

Sat Oct 19, 2019 10:34 am

batchelor wrote: ↑

Thu Oct 17, 2019 12:43 pm

Cheers for the information and pics. That’s a very clean bike.

No problem, and thanks.
It ended up as my Honda Britain but was just the only one I had with a clear picture of the side stand rubber fitted



Build thread here if you are bored , viewtopic.php?f=62&t=54015