Page 1 of 1

NC30 bar ends

Posted: Fri Jun 14, 2019 12:29 pm
by FreshPrince14
Just looking for a bit of guidance on NC30 bar ends. My apologies if this has been covered before. I used the search function but couldn't really find an answer.

Question is: Has anyone got any alternatives to factory NC30 bar ends? What other bar ends fit? Maybe some off other Hondas from the era?

Looking to get as close to a factory look as possible. Better again, if anyone has a decent condition set for an NC30 available then let me know. Problem is that most of them tend to have been deeply marked from falls and slides etc.

Cheers.

Re: NC30 bar ends

Posted: Sat Jun 22, 2019 2:37 pm
by richyrd5
Cbr600rr4 are same..you have to grind a small bit as they're staggered at the ends.. soon as they're flat they fit straight on and look oem.....