NC30/35 Engine Bearings

g-force performance · Post by **g-force performance** » Wed May 25, 2016 6:25 am

Just as a Heads-Up.

I am currently trying to pin down a quality source to make new rod and main journal bearings for our little engines. I have contacted the original company in Japan that makes the bearings for Honda. I am really hoping they will work with me. Otherwise, I have a couple of other possibilities like Clevite, Federal Mogul or possibly Mahle.

For these companies to take me seriously, my volume has to be large enough. So, I am curious to see how many of you would be interested in bearings if I were to get these done. Also, maybe some of you have some other sources you could recommend.

Looking forward to your response.

Mike Norman
G-Force Engine Development
www.mngforce.com

Post by **jpete41996** » Thu May 26, 2016 6:44 am

Mike, I would be interested in a set rods/mains. Price pending, of course.

Sent from my iPhone using Tapatalk

RichardJ · Post by **RichardJ** » Thu May 26, 2016 12:29 pm

I'd be interested, when the time comes!

richyrd5 · Post by **richyrd5** » Fri May 27, 2016 10:49 am

Yep,id go for a full set price depending!!

g-force performance · Post by **g-force performance** » Fri May 27, 2016 9:45 pm

I'm working on it. In one case, the price is going to be a deal regardless, if you can't get them anywhere else because they are NLA all over the world.. On the other hand, I am still going to try and get them to be close to the same as OEM. But, that just depends on how many I need to have made.

Post by **mwarriner** » Sun May 29, 2016 7:16 pm

Hi Mike, I would be interested in a couple of sets. Best, Mike.

Sent from my iPhone using Tapatalk

freeserve · Post by **freeserve** » Tue May 31, 2016 3:16 pm

Depending on price I maybe interested.

Sent from my SM-G925F using Tapatalk

Yakama · Post by **Yakama** » Tue May 31, 2016 9:26 pm

Yup I'd take a few sets too

Yakama · Post by **Yakama** » Tue May 31, 2016 9:41 pm

Vandervell who are part of the Mahle group are based near me if it helps

http://www.vandervell.co.uk

Post by **VFRkieran** » Sun Jun 19, 2016 10:03 pm

Also interested in minimum of one set possibly two, keep us updated on times scales and costs. I am ideally building up another motor for the Manx gp when the winter arrives.

NC30/35 Engine Bearings

NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings

Re: NC30/35 Engine Bearings