TAKING ORDERS: Cosworth 56mm & 57mm Pistons for 2016

[venom51]

I was just sticking my head in to say hello. I'm too broke right now with trying to do some MotoAmerica rounds to do anything with the 29. But eventually, I will be putting it back together and putting it back together in a big way. So I will be in touch.

Hope you're feeling better Mike. I will have to give you a call so we can catch up. Have you posted up about the Castec here?

Tell me you didn't buy one of those horrific little KTM 390 mopeds?

[panteleimon]

Hi Mike.

I'm also interested.
Again, can I check what the full cost would be incl rods?
Would be looking at 1-2 sets of the 57mm with +3mm rods.
Re: the rods - you mention HRC / Gforce - are these the Carrillo ones you have used or a different supply?
Please keep us updated.

Thanks!

[panteleimon]

Any updates?

[g-force performance]

Hi guys.

I am sorry for going missing on you. Life's been giving me some fits and twists lately. Unfortunately, while recovering from my 3rd cervical (neck) spine surgery I somehow broke my lumbar (lower) back in 2 places. This, caused me to lose my badass Dyno Engineer job with Honda Racing. So, now I am going in for yet another spinal surgery next week.

Needless to say, I have done nothing with the Cosworth pistons. I was able to source a new ring, but that would leave everyone with the previous pistons out in the cold for rings. So, I am still holding off on doing anything until I have exhausted the possibilities for getting new rings made to the Yamaha spec. I will work on this while recovering from this next surgery.

Don't be afraid to poke. I'm not a hornets nest. Just super busy and now very distracted.

Cheers,

Mike Norman

[Neosophist]

Hi guys.

I am sorry for going missing on you. Life's been giving me some fits and twists lately. Unfortunately, while recovering from my 3rd cervical (neck) spine surgery I somehow broke my lumbar (lower) back in 2 places. This, caused me to lose my badass Dyno Engineer job with Honda Racing. So, now I am going in for yet another spinal surgery next week.

Needless to say, I have done nothing with the Cosworth pistons. I was able to source a new ring, but that would leave everyone with the previous pistons out in the cold for rings. So, I am still holding off on doing anything until I have exhausted the possibilities for getting new rings made to the Yamaha spec. I will work on this while recovering from this next surgery.

Don't be afraid to poke. I'm not a hornets nest. Just super busy and now very distracted.

Cheers,

Mike Norman

get well soon fella, hope your next surgery is the last you need

[Yakama]

What about this company, they seem to produce Pistons for various 400s already and they make rings for the nc30

www.scheuerlein.de

[mruehl34]

I can ask them. But first Mike have to tell us if he can make some pistons

Michael

[Yakama]

Perhaps they could make the Pistons too?

[fourfingers]

Michael,
They also have the stock Yamaha 1WG-11610-00-00 rings (56mm), could you please ask them if they could make them in 57mm for the 2009 coswoth pistons?.
thanks

[mruehl34]

I talked to Scheuerlein, they told me that they have the 57mm pistonrings include the oil ring in stock.
A set will cost 199,90€ without shipping. Scheuerlein had more than 10 sets in stock.

Michael