recently bought an nc29. ive been driving it around for 2 weeks now. a few days ago the rear brake started making a strange sound, sorta like a low groan, like something's rubbing somewhere. it's interrupted but sometimes constant when i use it, and sometimes not there at all.
I've taken a futile look at it, but alas, i don't know much about these things...
i'm hoping its not a warped disc.
anyone have a clue?
thx
rear brake noise...help?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Posts: 3
- Joined: Mon Sep 12, 2011 7:44 pm
- Bike owned: cbr400
- Location: London
-
- Site Supporter
- Posts: 25
- Joined: Fri Apr 29, 2011 7:07 pm
- Bike owned: NC29 Import-ZZR600
- Location: Northumberland
Re: rear brake noise...help?
I have a ZZR with the same noise. I have checked the rear disc its grooved a warped I am going to change it
My NC29 rear disc is in much better condition and no noise , I have cleaned both still got the noise on the ZZR , its worse when the break disc warms up
Hope this helps
My NC29 rear disc is in much better condition and no noise , I have cleaned both still got the noise on the ZZR , its worse when the break disc warms up
Hope this helps
- selexon
- Site Supporter
- Posts: 114
- Joined: Wed Dec 08, 2010 9:55 am
- Bike owned: FZR400R 2TK, CBR400RR NC29
- Location: Launceston, Tasmania
- Contact:
Re: rear brake noise...help?
Sounds like a set of new pads and disc...
-
- Regular Member
- Posts: 560
- Joined: Wed Jun 03, 2009 9:39 pm
- Bike owned: Cbr400rr nc29 type8 NSR250
- Location: West Midlands
Re: rear brake noise...help?
If its when you use it, it could be the sliding pins that the calipers on need a clean and some fresh grease? 

-
- Senior Member
- Posts: 1184
- Joined: Thu May 01, 2008 6:42 am
- Bike owned: CBR400/600 Fighter
- Location: Mildenhall-Suffolk
- Contact:
Re: rear brake noise...help?
1) you need to get a manual & some spanners
2) unbolt the caliper from the rear while still attached by the brake hose.. remove the end can first.
3) check the wear level of the pads. do you see a wear groove?
4) clean with a wire brush all around the callipers/pads/pins.
5) reassemble back on to bike & see how it goes.
its not always a warped disk.. often just the calipers need a good clean from the road crud.
2) unbolt the caliper from the rear while still attached by the brake hose.. remove the end can first.
3) check the wear level of the pads. do you see a wear groove?
4) clean with a wire brush all around the callipers/pads/pins.
5) reassemble back on to bike & see how it goes.
its not always a warped disk.. often just the calipers need a good clean from the road crud.