Hello everyone hare is some pictures of my first bike project hopefully to be completed over the winter. the bike has has been stood up for about 5 years. so far ive stripped the rear end and taken the exhaust off ( has any one got any good tips for getting a snaped stud out there's about 5mm still sticking out the head ) and stoped it gushing fuel out the carbs. still have plenty to do so should be a busy winter.

http://s852.photobucket.com/albums/ab85/marccw/

to remove snapped studs etc, you can use a stud extractor to remove them, or alternatively good ole fashioned mole grips and a strong wrist usually does the trick. good luck mate

just cleaned up the down pipes and found a hole in them where the flange bolts to the engine, so was wondering if there is any one wanting to sell a full system for a 29 ??