NC30 headstock stand

alexwitham · Post by **alexwitham** » Wed Dec 26, 2012 9:01 pm

Looks like I'll be buying one of those then!

Baz · Post by **Baz** » Thu Dec 27, 2012 2:22 pm

I have one and it is solid. If you get one make sure you order the 27mm pin with it because I didnt realise I needed it until after the stand had arrived so had to order the pin afterwards. It cost £13 including postage. Still worth it though. Im doing my forks tomorrow so it will come in very handy!

Fitty · Post by **Fitty** » Thu Nov 28, 2013 8:42 am

Apologies for dragging up an old thread, but I'm looking at buying one of these stands and from the pictures it looks like the top half of the stand rotates on pins securing it to the bottom half. If that's the case, what is there to prevent the stand from rotating freely while the bike is on it?

Post by **bikemonkey** » Thu Nov 28, 2013 7:28 pm

Good question sir.

I don't know, but I've been using it for a while and it's never buggered off from underneath my bike

Post by **NGneer** » Sat Oct 21, 2017 5:02 pm

Old thread revival.

Anyone remember the name of the company that did these Headstock stands?

I am going to need one for my next project and as these were a German company and I an currently in Germany it seemed to make sense to see if they are still selling them.

Anyone got any contact details.......and am I correct that I will need a 27mm pin for the NC30 head?

Thanks

NC30 headstock stand

Re: NC30 headstock stand

Re: NC30 headstock stand

Re: NC30 headstock stand

Re: NC30 headstock stand

Re: NC30 headstock stand