NC30 Chain Adjuster Ring

VFRBen2k · Post by **VFRBen2k** » Fri Oct 23, 2009 9:08 am

So, mines mashed up and it needs a new one pretty badly after a recent chain and sprocket change.

I've been quoted about 200 quid for the part. I know they're expensive but I just needed to check this is about right and/or if theres anyone who does this part for less etc.

Thanks,

Ben

Post by **CMSMJ1** » Fri Oct 23, 2009 9:42 am

£200 is far too much. You can buy the whole hub assy for approx £50... a few guys on here sell bits - geoff33 is the one that springs to mind...

Also, get yourslef a proper C spanner for adjusting it too

#

Welcome to the site.

VFRBen2k · Post by **VFRBen2k** » Fri Oct 23, 2009 11:16 am

I thought I was getting done for that, thank you very much!

I now *have* a c spanner after making such a hash of my adjuster. Better late than never!

Thank you!

Ben

Post by **mick.mh2racing** » Fri Oct 23, 2009 9:47 pm

Even if yours has teeth that are mashed, take it off and file the teeth back square. If that's all that's wrong I wouldn't replace it.
And use your C spanner.

Post by **Sligeach** » Sat Oct 24, 2009 4:21 pm

just replace the hub, i got a reconditioned one off Grahame Frace, 75 posted to ireland IIRC. he is a guru and had it taken to pieces and cleaned and re-lubed it, buying off ebay will give you no guarantee of what the hub bearings are like.

NC30 Chain Adjuster Ring

NC30 Chain Adjuster Ring

Re: NC30 Chain Adjuster Ring

Re: NC30 Chain Adjuster Ring

Re: NC30 Chain Adjuster Ring

Re: NC30 Chain Adjuster Ring