A few questions

[Imp]

Hooray, my bike passed its MOT so is now up and running! Had to get the fork seals done sadly but has been ok otherwise.

Anyway, I have a couple of questions I was hoping people might be able to help me with.

Firstly:

After having the forks done, i've noticed that there is a hole (see picture) that looks suspiciously like its missing something. Should there be a pin here?? Bit worried something important is missing, don't want my front wheel coming off!



Second question:

Are there any cross-compatible exhaust systems? My exhaust is a bit scruffy and i'd like to maybe replace it, have seen a FZR400 one locally but not sure if it'd fit.

Thanks for any help!!

[RICKNC31]

Hi the hole you see is so that you can put a srewdriver or other in and stop the axle from spining as you tighten the axle nut on the other side it dose not need any pin in otherwise. As for the silencers fitting most exhausts could be made to fit with a bit of jigging a slipon can would probably be the easyest to fit but again unless listed as fitting your bike a bit of jigging would be neccessary hop this helps rick

[Imp]

Thanks Rick, thats a great help!