RVF400 Neutral light problem

Andy_Edw · Post by **Andy_Edw** » Tue May 22, 2012 12:23 pm

My neutral light on my nc35 flickers on & off when its in neutral, So i can't leave the bike running while on its stand because it thinks its in gear

Any suggestions?

Andy

Post by **CMSMJ1** » Tue May 22, 2012 12:37 pm

clean the neutral switch connectors...

Andy_Edw · Post by **Andy_Edw** » Tue May 22, 2012 12:47 pm

Where are they located?

Post by **CMSMJ1** » Tue May 22, 2012 12:52 pm

err..down near the gearbox - right hand side if I remember ! Near the dipstick

Mavirick · Post by **Mavirick** » Mon Jun 04, 2012 9:22 am

Change the bulb

Andy_Edw · Post by **Andy_Edw** » Mon Jun 04, 2012 7:32 pm

I checked all the wires, They were all fine

Can you even change the bulbs lol?

Post by **ibby4585** » Mon Jun 04, 2012 7:37 pm

You sure you got the right wire? It's a single spade end connectors thats really tight against wire easily to dislodge.

hannakournikova · Post by **hannakournikova** » Mon Jun 04, 2012 9:12 pm

Check clutch diode with working one. It's lhs sitting on the bike behind arse

magg · Post by **magg** » Tue Jun 05, 2012 12:27 am

Check that neutral switch gives consistent ground signal by measuring its resistance to chassis with a multimeter while the engine is running.