new to the forum and new project bike

[GIXERMARK0]

hi
wrote off my gixer 600 heavily moded to race spec so looked around for some thing different as fast aproaching 50 http://forums.mg-rover.org/showthread.p ... ost4427646

so looked around for an nc30 i had upto 2k to spend but was looking for a project bike but running i looked at a few and was not impressed one was in bham going for £1695 back wheel dinked tank dented fairing oput of line brakes sezed ect and this was at a dealers so walked away

then i found my ideal bike for £700 yep could not belive it 1995 registerd in 1996 and 5 owners in the same family
scroll down for the photos of the bike as i got it :broon: http://forums.mg-rover.org/showthread.php?t=422835

so far done the front forks , full service (thats why i asked about the oil in another thread) nc31 17 inch rear wheel 30mm jack up att the back
been poloshing all the ally fited a new exhaust can (TYGA MOTO MAGGOT CAN ) sounds brill
i have got 2 SP2 calipers to fit and a gixer radial master changed clutch lever to gixer as had a set of pazzo levers just need lines and new discs
next step over winter is ram air ecu upgrade and re paint the body work
also have an electric fuel pump for bigger jets
i have a full gixer fairing kit so might see if it fits will be a little different
so now doubt ill be bending your ears on other mods

regards mark

ps how do you post photos on here

[mick.mh2racing]

viewtopic.php?f=6&t=7902
Click the link to the photo thing, project sounds well on the way.