some advise would be great

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
gilly1
Settled in member
Posts: 15
Joined: Wed Dec 16, 2009 12:40 pm
Bike owned: NC30, SV650 race bike
Location: Nottingham

some advise would be great

Post by gilly1 » Tue Feb 15, 2011 8:05 am

Hi people,

i am getting to the last few bits of my NC30 racebike for this seasons racing. im runnig a full HRC exhaust system and a hrc rep air scope (open carbs with no filter) and total loss, but apart from that it is standard.

what jet sizes would you people recommend and is there anything else i should do to the carbs?

what pads do you recommend for standard calipers?

what gearing do you race lads run at mallory park?

any help would be great :grin: thanks

Andrew

User avatar
CMSMJ1
Moderators
Moderators
Posts: 7152
Joined: Thu May 01, 2008 9:42 am
Bike owned: NC30-No9
Location: Chesterfield, United Kingdom

Re: some advise would be great

Post by CMSMJ1 » Tue Feb 15, 2011 8:43 am

I reckon you will need to spend the money and get it dyno'd to make sure of a good setup on them carbs,

You know the BMC gang, I'd recommend you let Mike loose on it for an hour or 2 and get it dialled in. Have you bought the HRC kit for the carbs? What you doing for the trumpets or to shiels the air jet?? Can we get some pics of the setup?
Jetting on open carbs is a bastard..as I was going to run it like that last year and I ended up sacking it and ran std airbox and it fuelled lovely. Open carbs is not as simple as just not running a filter

Gearing - 14/41 is pretty much bob on.
IMPERATOR REX ANGLORUM

The V4 is the law..

NC30 - No9 - my old mate

User avatar
Cammo
Site Supporter
Site Supporter
Posts: 4505
Joined: Thu May 01, 2008 12:35 am
Bike owned: NC30
Location: Melbourne, Australia

Re: some advise would be great

Post by Cammo » Tue Feb 15, 2011 9:32 am

CMSMJ1 wrote: Have you bought the HRC kit for the carbs?

Open carbs is not as simple as just not running a filter
:plus:

If you don't have the rest of the hrc gear in the carbs (emulsion tubes, pilot jets, needles, velocity stacks, etc) then you'll need 160+ size jets and it will run like a pig with a massive midrange hole that will be hard to get the bike to rev through.

With all the right parts the power delivery is peaches and cream smooth with good top end power! :ninja:

The TT F3 manual lists all the carb parts, most can be had (or replicas) plus some work arounds done (particularly regarding the velocity stacks - quite rare now):
http://www.400greybike.com/docs.htm
"It's just a ride" Bill Hicks

gilly1
Settled in member
Posts: 15
Joined: Wed Dec 16, 2009 12:40 pm
Bike owned: NC30, SV650 race bike
Location: Nottingham

Re: some advise would be great

Post by gilly1 » Tue Feb 15, 2011 11:28 am

thanks for your help guys. i am going to run standard airbox to get the bike on the track. do you have an idea of what jet sizes i will need running the standard airbox with the HRC exhaust system? thanks for help :grin:

User avatar
CMSMJ1
Moderators
Moderators
Posts: 7152
Joined: Thu May 01, 2008 9:42 am
Bike owned: NC30-No9
Location: Chesterfield, United Kingdom

Re: some advise would be great

Post by CMSMJ1 » Tue Feb 15, 2011 12:14 pm

I run 120s with a full system and std airbox. It is lovely..should get you thereabouts anyways!!
IMPERATOR REX ANGLORUM

The V4 is the law..

NC30 - No9 - my old mate

Neosophist
Moderators
Moderators
Posts: 8172
Joined: Fri Jul 04, 2008 1:01 pm
Bike owned: CBR954

Re: some advise would be great

Post by Neosophist » Tue Feb 15, 2011 8:08 pm

CMSMJ1 wrote:I run 120s with a full system and std airbox. It is lovely..should get you thereabouts anyways!!
Good call..

What air-filter do you plan on running with the bike?
xivlia wrote:i dont go fast on this bike so really do not need a rear brake.. /
vic-vtrvfr wrote:Ask xivlia for help, he's tackled just about every problem u could think of...

Post Reply